Easy Ways to Install Bricomania Emergency Light

Jul 2nd

Emergency light – An emergency light is a practical solution in order to have a point of light in the home during times of blackouts. Therefore, below we will show you step by step how to install an emergency light. The first thing that we will have to do is cut the electric current, to avoid possible accidents. Next, we open the lid with a screwdriver and release the base of the lamp.

Exterior Emergency Lighting Battery Backup

Present the piece on the wall, well leveled, about two meters above the ground, and mark the fixing points. With the drill in percussion position and a wide bit of the right diameter, we make the holes. Next, we introduce the plastic plugs. Present the screws, strip the cables and remove the strip. Next, we insert the colored ducts in their corresponding terminals and place the base in its position. Once we have tightened the screws, we mount the emergency light again.

24 Photos Gallery of: Easy Ways to Install Bricomania Emergency Light

Image of: Exterior Emergency Lighting Battery Backup
Image of: Exit Signs With Emergency Lights
Image of: Exit Sign With Battery Backup
Image of: Exit Lights With Emergency Lighting
Image of: Emergency Lighting Fixtures
Image of: Emergency Exit Lights
Image of: Emergency Exit Lights With Battery Backup
Image of: Battery Powered Exit Signs Home Depot
Image of: Weatherproof Emergency Lights
Image of: Outdoor Emergency Lights
Image of: Lighted Exit Signs With No Electricity
Image of: Led Emergency Lights For Buildings
Image of: Vintage Emergency Light
Image of: Track Emergency Light
Image of: Super Bright Emergency Light
Image of: Solar Powered Emergency Light
Image of: Renote Control Emergency Light
Image of: Rechargeable Emergency Light
Image of: Powercraft Emergency Light
Image of: Portable Emergency Light
Image of: Led Emergency Light
Image of: Emergency Light Charging Tents
Image of: Electrical Emergency Light
Image of: Car Emergency Light

Now we only have to activate the current again and let the battery charge of emergency light for 24 hours. The luminaries have a small green warning light. To conserve the good state of the battery, it is convenient to make complete discharges every 10 weeks approximately. For that, we disconnected the current from that point of light and wait for the fluorescent lamp to turn off to reconnect it. From now on, in case of failure in normal lighting, we will have a margin of time to solve the problem.